Tapered wood filler strips placed along the butt ends of old wood shingles to create a relatively smooth surface when reroofing over existing wood shingle roofs. Referred to in some regions of the country as “horse feathers,” or leveling strips.
Tag: repairs
Flashing Failure
The function of flashings is to provide a watertight junction between roofing materials and roof projections or other parts of the structure, and between roof sections. Flashings should be designed to furnish service for at least as long as the materials used in the field of the roof. Flashings are the most vulnerable part of any roof. Their importance and the importance of maintaining them properly cannot be overemphasized.
Many early roof problems are actually flashing problems. Often, repairing the flashings or providing new flashings is all that is needed to make the roof watertight again. Most flashing problems result from inadequate flashing design or faulty construction. Many flashing problems can be reduced or eliminated by careful examination by competent inspectors during roof installation, and by regularly scheduled inspection and maintenance.
In many instances, leaks occur at flashings where there are no flashing defects. These leaks may be the result of open joints in a masonry wall or coping cap, which permits water to enter behind the flashings and into the building. This problem may be eliminated by “through-wall” flashings.
Hail Damage
Hail forms when frozen water drops are lifted in turbulent wind regimes during thunderstorms. The frozen drops of water increase in size and eventually fall to earth as hail having been driven by a combination of gravity and wind forces. Hail stones vary in size from pea size (1/4 inch diameter, little roof damage), through marble size (3/4 inch in diameter, threshold damage to roof materials) to golf ball size (11/2 inch in diameter, typically severe damage to roofing materials). Hail size distributions tend to be localized with some roofs damaged, while others are not. Wind direction plays an important role, as well as roof pitch. A direct impact of hail on a shingle is more damaging than that of a glancing blow.
Assessing hail damage is often accomplished by a roof inspection, which usually occurs several days to several months after the hail event. Determination of whether hail actually fell at a site can be made through statements and weather reports. Inspection of thin, aluminum fixtures helps verify hail impact.
Re-Cover
The addition of a new roof membrane or steep-slope roof covering over a major portion of an existing roof assembly. This process does not involve removal of the existing roofing.
Re-Roofing
The process of re-covering, or tearing-off and replacing an existing roof system
Roof Replacement
The practice of removing an existing roof system down to the roof deck and replacing it with a new roofing system.
Weather Damage
All roofing materials deteriorate from exposure to the weather at rates determined largely by the kind of material and the conditions of exposure. In general, inorganic roofing materials tend to deteriorate less rapidly from exposure than organic roofing materials. All types of roofing materials may be damaged by hail. Exposure to air pollutants and industrial or salt-laden atmospheres may accelerate the deterioration process of some roofing materials.
Wind Damage
Roofing materials are subject to damage from strong winds and flying debris. Generally, roofs are not designed to withstand winds of hurricane and tornado intensity. However, roofs may also be damaged by winds of moderate intensity, with gust that may reach 50 to 75 miles per hour. The primary cause of wind damage is from the partial vacuum created by wind blowing over the edge of the roof. Nature tries to neutralize the low-pressure area by bringing in air from a higher pressure area, usually from inside the building. This air pushes up on the bottom side of the roof assembly and, over time, loosens fasteners and breaks the adhesion making the roof susceptible to damage from the next moderate or strong wind. To counteract the effects of wind-uplift forces, the roofing and insulation should be adequately fastened to the roof deck, and a securely-fastened perimeter detail should be provided.